Dell TL2000 manual Installing the Replacement Library Enclosure

3)Grasp the top and bottom edges of the power supply and pull it out of the library.

b.Install the power supply removed from the defective library in the replacement library enclosure. Install the power supply removed from the replacement library enclosure in the defective library to return to Dell. To install a power supply:

1)Grasp two of the thumbscrews and push the power supply into the library.

2)Tighten the thumbscrews.

a66mi096

Figure 10-23. A power supply being removed from a library

3.Plug the power cord into the replacement library enclosure then into a power source.

4.Power ON the replacement library enclosure. a. If power ON is successful:

1)The replacement library enclosure will power up with the

Ready/Activity LED ( in “Unpacking and Preparing the Replacement

Library Enclosure” on page 10-12)ON.

2)Power OFF the replacement library enclosure.

3)Unplug the power cord from the power source then from the library.

4)Proceed to “Installing the Replacement Library Enclosure.”

b.If power ON is not successful, contact Technical Support for further instructions.

Installing the Replacement Library Enclosure

Refer to the appropriate procedure in this section (rack or desktop) for installing the replacement library enclosure.

Note: If you are shipping the replacement library enclosure to a remote location, install the shipping lock and label before shipment.

Chapter 10. Check, Adjust, Remove, and Replace 10-23