1.Navigate to Move Cartridges using the Operator Control Panel (Control Move Cartridges).

2.Select Source.

3.Scroll through the different slots containing cartridges, and look for an exclamation point (!). The exclamation point indicates that the cartridge is bad or was rejected due to wrong format, write protected, etc..

4.Select the marked cartridge as the Source and the I/O Station as the Destination (Dest.).

5.Select Move.

6.Open the I/O Station (Control I/O Station).

7.Remove the marked cartridge from the I/O Station and dispose of properly.

8.Close the I/O Station. If the amber LED was lit because of bad media, the Attention LED will turn OFF. If the amber LED is still on, check the power supply or the power supply fans. See “Isolating a Power Supply Problem” on page 7-8.

Chapter 7. Troubleshooting 7-13

Page 167
Image 167
Dell TL2000 manual Troubleshooting