10.Press the CANCEL button until the Home screen displays.

11.Press the CANCEL button to return to the home screen.

12.Power cycle the library to initialize your configuration.

Logging on to the Web User Interface

To complete the configuration of your library using the Web User Interface, follow the steps below.

1.Return to the Home screen on the Operator Control Panel.

2.On your host computer, open Internet Explorer.

3.In the browser address field, enter your library’s IP Address. For DHCP, enter...

a.For DHCP, use the Operator Control Panel to determine the IP Address assigned to your library. Navigate to Monitor Library Identity. Scroll down to IP Address and make note of the address. Enter the IP Address in your internet browser address field to access your library with the Web User Interface.

b.For IPv4 or Dual Stack IPv4 + IPv6, enter your library’s static IP Address using the 0.0.0.0 format (four octets).

c.For IPv6, enter your library’s static IP Address or Router Assigned IP Address using the following format: http://[0:0:0:0:0:0:0:0]. To determine your Router Assigned IP Address, navigate to Monitor Library Network on the Operator Control Panel. For the IPv6 Router Assigned Addresses to be displayed on the Operator Control Panel, the Network must be configured to IPv6 Only and the Stateless Autoconfig on the must be set to ON.

4.When the login screen appears, v Select admin for a User ID v Enter secure for a Password

a77ug070

Figure 4-18. Log in screen on the Web User Interface

Verifying/Updating Firmware

It is important to run the latest level of firmware. To ensure that you are running the latest levels of library and drive firmware, complete this procedure.

1.Verify the levels of library and drive firmware currently installed on your library.

a.Expand Monitor Library in the left navigation pane of the Web User Interface.

b.Click Library Identity and make note of the Firmware revision.

c.Click Drive Identity and make note of the Firmware revision.

d.Log out of the Web User Interface.

2.Download the latest library and drive firmware from http://support.dell.com.

Chapter 4. Installation and Configuration 4-17

Page 67
Image 67
Dell TL2000 manual Logging on to the Web User Interface, Verifying/Updating Firmware