Dell TL2000 manual Entering Path Failover Feature Activation Key, Setting Up Encryption

a77ug098

Figure 4-21. The 4U library Configure Library: Logical Libraries page

2.Select the number of logical libraries you would like to create in your library.

3.Click Submit to create the logical libraries.

Entering Path Failover Feature Activation Key

The Path Failover feature is available for select LTO 4 tape drives. Path Failover is not supported for half height drives. For more information, refer to the Dell PowerVault TL4000 Failover Configuration Guide, included with the library documentation.

1.Click Path Failover in the left navigation pane.

a77ug117

Figure 4-22. The Configure Library: Path Failover Feature Activation screen

2.Enter the Control Path Failover 12-digit feature key in the spaces provided.

3.Click Activate to save the feature key. The following screen will display if you have correctly entered the feature key.

a77ug118

Figure 4-23. Feature Key verification screen

Note: Follow the instructions in the Dell PowerVault TL4000 Failover

Configuration Guide to configure your environment for failover.

Setting Up Encryption

Note: Application Managed Encryption (AME) does not require a key. Library Managed Encryption requires a license key. The customer should contact their TSR (technical sales representative) to purchase this feature.

Prerequisites for Application Managed Encryption:

vSAS and Fibre Channel LTO Ultrium 4 Tape Drive (Full Height or Half Height) Note: Fibre Channel is full height drive only.

vUltrium 4 Tape Cartridge

vLibrary firmware level 5.80 or higher

vDrive firmware level 77BE or higher

Chapter 4. Installation and Configuration 4-21