Dell TL2000 manual Rack Kit Mounting hardware

1.Verify that your rack kit includes the following contents (see Figure 4-6): v Packaged in plastic material:

– 2 rails (not shown)

– 2 mounting brackets ( )

vPackaged in the small bag with no label:

–	1	T10 Torx wrench (	)
–	2	U-shaped anchors (	)
–	4 small screws for securing the anchors and brackets ( )
–	2 large screws to secure the mounting brackets to the rack ( )

vPackaged in the small bag with ″Round Hole″ on the label: 9 screws to be

used on racks with round holes. ( )

vPackaged in the small bag with ″Square Hole″ on the label: 9 screws to be

used on racks with square holes. ( )

Note: Eight screws are needed for the installation. One additional screw is provided for security.

2 3

4

1

5

a77ug208

7 6

Figure 4-6. Rack Kit Mounting hardware

2.Determine the location in your rack for your library to be installed and, using a pencil, mark the location on each vertical rail in your rack.

Note: A 2U library requires 2U (3.5 in.= two EIA) of rack space. A 4U library requires 4U (7 in. = four EIA) of rack space

Chapter 4. Installation and Configuration 4-7