5.Turn ON the library using the power button. Check the Operator Control Panel display to make sure the library is receiving power. If it is not, check the power connections and your power source. During the
Configuring Your Library
Note: Review the information in ″Installation Planning″ before configuring your library.
The library can be configured using the Operator Control Panel and/or the Web User Interface. The recommended method for configuring your library is using the Web User Interface.
For complete detailed configuration information on all of the functions available on your library using both the Operator Control Panel and the Web User Interface, see Chapter 5, “Operations,” on page
Restore Defaults” on page
Choosing Your Configuration Method
If you choose to use the factory defaults for your library configuration, go to “Using Factory Defaults as Your Configuration” on page
If you choose to use the Web User Interface for configuring your library, go to “Configuring Your Library using the Web User Interface” on page
If you choose to use the Operator Control Panel for configuring your library, go to “Configure Menu” on page
vLogical Libraries
vLibrary Settings
vDrive(s)
vNetwork
vSet Access PIN
vSet Date and Time
vPath Failover
To complete the configuration of your library, the following items will have to be accessed from the Web User Interface:
vEncryption (see “Configure Library: Encryption” on page
vUser Access Information (see “Configure Library: User Access” on page
vLogs and Traces (see “Configure Library: Logs & Traces” on page
vEvent Notification Information (see “Configure Library: Event Notification” on page
vKey Path Diagnostic (see “Service Library: Perform Key Path Diagnostics” on page
vUpdating Firmware (see “Service Library: Upgrade Firmware” on page