Dell TL2000 manual Installation and Configuration

–Bar code labels

–Foot pads (for desktop installation)

v With every library containing a SCSI drive:

–SCSI terminator (one per SCSI drive)

–SCSI library-to-host cable (if ordered by customer)

vWith every library containing a Fibre Channel drive:

–Fibre Channel library-to-host/switch cable (if ordered by customer)

vWith every library containing a SAS drive:

–SAS library-to-host cable (if ordered by customer)

vRack Mount Kit

Installing the Library Foot Pads (for Desktop Installation ONLY)

Important: Operating your library on a flat surface without foot pads may damage your library or cause it not to function properly..

Six foot pads must be installed on the bottom of the library before the library can be used as a desktop unit. If you intend to install your library in a rack, skip this step and proceed to “Removing and Storing the Shipping Lock” on page 4-4.

To install the library foot pads:

1.Being very careful, lay the library on its side.

2.Peel the adhesive from the back of each foot pad.

3.Install the foot pads on the bottom of the library enclosure by pressing each

foot into one of the six areas ( ) as shown in the figure below.

Chapter 4. Installation and Configuration 4-3