Important: Push in on the drive sled handle ( in Figure 10-5 on page 10-4)while supporting the bottom of the drive sled until it is properly seated. Damage to the connector pins may occur if this procedure is not followed.

10.Push the drive sled slowly into the drive slot until the sled seats itself against the back of the library.

a77ug028

Figure 10-7. Pushing the drive sled into the library (drive sled without ESD springs shown)

11. Tighten the captive thumbscrews (

in Figure 10-5 on page 10-4)until the

drive sled is secure.

 

12.If you are installing a drive sled without ESD springs (see Figure 10-3 on page 10-3), apply conductive tape to the sled as shown in Figure 10-8 on page

10-7.

10-6Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide

Page 192
Image 192
Dell TL2000 manual A77ug028