Select this choice to cancel your changes and restore the factory settings.
•Exit Setup
If you have made any changes, the program will prompt you to save the changes or exit without saving the changes.
Using passwords
The System Security choice appears only on the full Configuration/Setup Utility menu. After you select this choice, you can implement two levels of password protection:
Power-on password
After you set a
You can use any combination of up to seven characters
•If an administrator password is set, enter the administrator password at the
•Change the position of the password override jumper as described in “Setting the password override switch”.
•Remove the battery and then install the battery.
Setting the password override switch: The following illustration shows the location of the password override switch, switch 8 of switch block 1, on the system board.
Note: The illustrations in this document might differ slightly from your hardware.
Switch block (SW1)
OFF | 12 |
| 3 |
| 4 |
| 5 |
| 6 |
| 7 |
| 8 |
To set the password override switch:
1.Review the information in “Before you begin” on page 42.
34 Hardware Maintenance Manual: xSeries 330