Furuno CH-250 manual Preset key, Activating custom mode

7.Press or to select PRESET KEY or SHORT-CUT KEY as desired.

8.Press the [MENU] key twice to register your selection and close the menu.

5.3.2Preset key

1.Select PRESET KEY following the procedure in paragraph 5.2.1 on page 5-3.

2.Press the [MENU] key to open the menu.

3.Press to select MENU, and then press or to select PRESET.

	MENU	COM1 COM2	HORZ	VERT ES		PRESET		SYS
		MODE SECTOR	TRAIN	RANGE	TILT		SPEED
	PRESENTCUSTOM3	360￿	0￿	160		30￿	NORM
12		240	0	160	30		FAST
		360	0	160	30		FAST
		180￿	90￿	120		90￿	FAST

ADJUST THE KNOBS AND FUNCTION KEYS TO THE DESIRED SETTING,

THEN PRESS A CUSTOM MODE KEY TO SAVE THE SETTING.

FUNCTION KEY: ENTRY MENU: END

Figure 5-5 PRESET menu

4.Set the [MODE], [SECTOR], [TRAIN], [RANGE], [TILT] and [FAST SCAN] controls according to target fish or fishing area.

5.Press the CUSTOM MODE keys [1], [2] or [3] to program. You are asked if you want to save the settings to the custom key pressed. (In the example, the custom key [1] was pressed.)

SAVE THE SETTING TO CUSTOM1 KEY?

NO YES

: CHANGE MENU: END

6.Press to select YES.

7.Press the [MENU] key. The message “PRGM SET” appears at the screen top.

8.Press the [MENU] key to finish.

Activating custom mode

1.Press appropriate CUSTOM MODE key. The indication CUSTOM1, CUSTOM2 or CUSTOM3 appears at the top of the screen depending on key pressed.

2.To escape from the custom mode operation, operate any of the controls among [MODE], [SECTOR], [TRAIN], [RANGE], [TILT] and [FAST SCAN].

5-6