Eagle Electronics 320 manual

Page 45

Adjusting sensitivity in Manual Sensitivity Mode is similar to driving a car without cruise control — you have complete manual control of the car's speed. In the sonar unit, manual mode allows you to set sensitiv- ity at 100 percent (maximum) or zero percent (minimum.) Depending on water conditions, the bottom signal may completely disappear from the screen when you reduce sensitivity to about 50 percent or less!

Fig. 1

Fig. 2

Fig. 3

Fig. 4

These figures show results of different sensitivity levels on the same location. Fig. 1: Sensitivity at 88 percent, determined by Auto Sensitiv- ity. Typical of full auto mode. Fig. 2: Sensitivity set at 75 percent. Fig.

3: Sensitivity set at 50 percent. Fig. 4: Sensitivity set at 100 percent.

Try adjusting sensitivity in both auto and manual modes to see how they work.

41

Image 45
Contents FishMark 320 SeaFinder 320DF Page Table of Contents Fish I.D. Fish Symbols & Depths How this manual can get you out on the water, fast Read Me FirstGeneral Figuration and installation, bottom composi How Sonar Works How to use this manual typographical conventionsPage Page Preparations Transducer InstallationDual-frequency transom installations Single-frequency transom installationsSingle-frequency trolling motor installations Shoot-through hull installationsGood and poor transducer locations Transom Transducer centerline Hull bottom Dot Transom Transducer Assembly and MountingAlignment Alignment lettersPositions TransducerRatchets Metal Nut Washer Rubber Bolt Flat washer Lock washer NutWashers BoltTransom Bottom HullFlat-bottom hull Deep-vee hull Internal tooth washer TMB-S bracket Bolt Nut Flat washer Transducer aimed Partial fish archesToo far back Full fish arch Proper transducer angleSHOOT-THRU-HULL Preparation Transducer location High speed Trolling speed Spread epoxy here Sand this surface Speed/Temperature SensorsRear view Sonar unitGood location Transom Bottom of hull Power ConnectionsOptional power off switch for Power c able Accessory Transducer Cable Sonar unit Rear view Power/transMounting the Unit Bracket, In-Dash or Portable Ducer socketFront 173.9 23.4 137.9 157.9 Millimeter 56.9 Inch 72.9113.5 Millimeters Inches 146.5Face Cover Cell batteryKeyboard Basic Sonar OperationPower/lights on and off Menus Main Menu Commands Sonar Menu Commands Pages Sonar Page, showing full sonar chart mode. bar graph Page Basic Sonar Quick Reference Sonar Operations Page Important Tip To Restore Factory SettingsPage Page Sonar Options & Other Features Alarms To adjust and turn on the shallow alarm To adjust and turn on the deep alarmTo adjust and turn on the zone alarm Brightness To turn the fish alarm onCalibrate Speed Chart SpeedContrast Depth CursorDepth box To switch to Manual Depth Range Depth Range AutomaticDepth Range Manual FasTrack Fish I.D. Fish Symbols & DepthsTo turn Auto Depth Range on again Bar graphPage Page FishTrack Symbols with FishTrack depthsFishReveal Press → ↓ to Fish ID DepthsentexitexitPage Fish Not Visible Fish arch Fish arches Frequency Change Transducer Frequency SeaFinder 320DF onlyGrayline Grayline Hard Bottom Muddy bottom Hard Fish nearNoise Rejection HyperScrollOverlay Data Hard Muddy bottom bottom GraylineTo change displayed data font size To turn off displayed dataPing Speed & HyperScroll Page Pop-up Help Reset OptionsReset Water Distance Screen Contrast and BrightnessSensitivity & Auto Sensitivity Page Set Keel Offset Press MENUMENU↓ to SET Keel Offsetent Set Language Software Version InformationPress MENUMENU↓ to Software Infoent Sonar Chart Display Options Sonar Color ModePage Page Customizing the Digital Data/Chart Screen Sonar Simulator Stop ChartPress ↓ or ↑ to select clarity levelEXITEXITEXIT Surface ClarityZoom & Zoom Bar Units of MeasureZoom Pan Page Troubleshooting Page Noise Page Page Page Supplemental Material How to Obtain Service… Accessory Ordering Information for all countries Visit our web site
Related manuals
Manual 200 pages 25.32 Kb Manual 128 pages 61.27 Kb