Ratchet
To mount the sonar, slide the unit onto the bracket from above (left). To adjust the view, press and release
Portable Transducer Assembly
Make sure there is one washer on each side of the transducer, inside the bracket. Slide the other washer over the end of the bolt and screw on the nut.
Screw the suction cup onto the bracket using the supplied screw and flat washer. Tie the nylon cord through the hole in the top of the bracket. When using the transducer, tie the other end of the nylon cord to the boat. This will help prevent losing the transducer if it comes off. Clean the chosen area of the hull before attaching the suc- tion cup. Locate the transducer on the hull as shown in the following figure. Don't let the bracket extend below the hull, because water pres- sure against it can cause the suction cup to come off at speed.
Hull
Portable transducer installed on
boat transom.
19