Furuno 1933C, 1943C, 1833C, 1823C, GD-1900C STC curve setting window, Heading data setting window

3.3.8STC CURVE

The default STC curve can be maintained in most cases. If necessary the STC curve can be changed as follows:

1.Open the RADAR SETUP menu and select STC CURVE.

2.Press the EDIT soft key or [ENTER] knob to show the setting window.

STC CURVE

NARROW

NORMAL

WIDE

RETURN

STC curve setting window

3. Select STC curve;

NARROW:	The effective range of the [A/C SEA] adjustment is relatively short.
NORMAL:	Between NARROW and WIDE.
WIDE:	The effective range of the [A/C SEA] adjustment is relatively long.

4. Press the RETURN soft key to finish.

3.3.9HEADING DATA

Select the heading reference, MAGNETIC or TRUE. Select MAGNETIC when connecting with the magnetic compass, select TRUE when connecting with the true compass. For your reference, when connecting with Satellite Compass SC-60/120 or Integrated Hading Sensor PG-1000 which Furuno makes, set the heading data as the table shown below.

	Model		Setting of HEADING DATA
PG-1000		with L/L data	TRUE
		w/o L/L data	MAGNETIC
SC-60/120			TRUE

1.Open the RADAR SETUP menu and then select HEADING DATA.

2.Press the EDIT soft key or [ENTER] knob to show the setting window.

HEADING DATA

MAGNETIC

TRUE

Heading data setting window

3.Select MAGNETIC or TRUE.

4.Press the [ENTER] knob or ENTER soft key.

3-10