Furuno GP-1650WD installation manual Beacon receiver, Installation of Dgps beacon receiver

Page 26

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)

 

J1

Cable assy.

J3

S.FL2-2LP0.7-D-WHT (175)

 

Notch

Beacon receiver

GR-7000A

Cable assy.

S.FL2-2LP0.7-D-WHT (121)

Beacon receiver

8.Connect cable assy. S.FL2-2LP0.7-D-WHT (121) (supplied) to J3 of the GR-7000A.

9.Close the lid of the GR-7000A.

10.Connect connector assy. PH6P-W-L240 to J2 of GR-7000A (Refer to the next page).

11.Fasten the GR-7000A (Beacon receiver) to the heat sink with four M3X10 screws (supplied) as shown in the figure below.

Pan-head Screw B

M3X10, 4 pcs.

Connect to

J8 on ANLG

Board.

S.FL2-2LPO.7-D-WHT (121)

Connect to

J2 on GN-8091.

Connect to

J106 on

MAIN Board.

Connect to J107 on MAIN Board

Cable Assy.

PH6P-W-L240

Cover of GR-7000A

Notch

Beacon Receiver Board

GR-7000A

GN-8091

Heat sink

Installation of DGPS beacon receiver

18

Image 26
Contents Installation Manual Color GPS/PLOTTER Page Safety Instructions Page System Configuration Standard supply Optional equipmentOptional equipment con’t IiiThis page is intentionally left blank Tabletop, overhead mounting methods Installation of Display UnitMounting considerations Mounting procedure Tabletop, overhead mounting of display unitFlush mounting of display unit Installation of Antenna UnitHow to assemble the connector Display unit, rear view Power cableConnecting the power cable to the battery Extending antenna cable length Antenna unitGround Cable extension TNC-PS-3D-15 Waterproofing connectorCable extension CP20-01700, CP20-01710 How to attach the N-P-8DFB connector Fabrication of coaxial cableOutput format window Port Nmea SettingNmea port Dgps port RTCM104 OutputOutput Data Sentences Select sentence windowAntenna Height Ant. height windowDgps Setting Dgps options windowBeacon frequency window Beacon baud rate windowIncorporation of Dgps Beacon Receiver KIT for GP-1650W Disassembly Removing cover assemblyDismounting chassis assembly Cutting cable tiesChassis assembly Handling of Coaxial CableInstallation of Dgps beacon receiver Beacon receiverWiring the Cable assembly Attaching chassis assemblyAttaching cable tie Remounting the coverGaskets Checking the beacon receiver Memory, I/O Test DisplayPacking List GP-1650WD/WDF E019 GP-1650WD/WDF (E 工事材料表 20AG-X-9405 Page Page Feb Feb Page Page Page Page 00080935910