Furuno GP-1850WD installation manual Nmea Setting, Nmea port, Output format window Port

Page 17

3.INITIAL SETTINGS

3.1NMEA Setting

NMEA port

This setting should be done when connecting with other equipment, autopilot, radar or remote display.

1.Press the [MENU] key.

2.Press the CONFIGURATION soft key.

3.Press the SETUP NMEA PORT1 soft key.

4.Press the cursor pad to select FORMAT.

5.Press the EDIT soft key to display the following window.

	▲	OUTPUT FORMAT	SETUP
	▲		PORT1
			PORT1
		▲
		NMEA0183 Ver1.5
		NMEA0183 Ver2.0
		▼
			ENTER
	DGPS 3D		CANCEL
	DGPS 3D

Output format window (PORT 1)

6.Select NMEA version depending on the specification of the equipment connected. The selected item is indicated by black button.

7.Press the ENTER soft key.

8.Press the [PLOT] key to return to the plotter display.

9

Image 17

Contents Back Page Safety Instructions This page is intentionally left blank System Configuration Optional equipment Standard supplyIii Optional equipment con’tThis page is intentionally left blank Tabletop, overhead mounting methods Installation of Display UnitMounting considerations Tabletop, overhead mounting of display unit Mounting procedureTabletop, overhead mounting Flush mounting of display unit Flush mountingHow to assemble the connector Installation of Antenna UnitDisplay unit, rear view Power cableConnecting the power cable to the battery Extending antenna cable length Antenna unitGround Waterproofing connector Waterproofing connectorExtension cable line-up in case of 15 m, 30 m or 50 m Cable extension CP20-01700, CP20-01710Fabrication of coaxial cable How to attach the N-P-8DFB connectorOutput format window Port Nmea SettingNmea port RTCM104 Output Dgps portSelect sentence window Output Data SentencesAnt. height window Antenna HeightInput/Output data sentences DGPS/WAAS options window Dgps SettingBeacon baud rate window Beacon frequency windowGR-7000A-1650-15N-019S GR-7000A-1650-10N-019Removing cover assembly DisassemblyProcedure Chassis assembly Installation of beacon receiverDismounting chassis assembly Connecting the coaxial cables in GR-7000A Installation of Dgps beacon receiverAttaching cable tie Wiring the Cable assemblyRemounting the cover Attaching chassis assemblyMemory, I/O Test Display Checking the beacon receiverThis page is intentionally left blank ＰａｃｋｉｎｇＬｉｓｔ GP-1850WD（E019 GP-1850WD（E 工事材料表 20AG-X-9405 Page Page Feb Feb Page Page 指示器 Page 00080936710