Furuno GP-1850W Installation of Dgps beacon receiver, Connecting the coaxial cables in GR-7000A

Page 26

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1850W)

Handling of Coaxial Cable

•Do not touch the connector with bare hands; use gloves.

•Use radio pincers to remove, and pull out straightly.

•Plug in connector straightly.

3.Fasten the GR-7000A (DGPS beacon receiver) to the heat sink with four 3X8 screws as shown in the figure below.

Screws (3 X 8), 4pcs.

DGPS beacon receiver

GR-7000A

GN-8091

Installation of DGPS beacon receiver

4. Open the cover of GR-7000A to connect two coaxial cables shown below.

J2

J1

Mini pin coax. cable

J3

Piece of shrink tubing

From GN-8091

Cable assy.

S.FL2-2LP0.7-D-WHT (250) (Supplied with DGPS kit)

Connecting the coaxial cables in GR-7000A

18

Image 26

Contents Back Page Safety Instructions This page is intentionally left blank System Configuration Standard supply Optional equipmentOptional equipment con’t IiiThis page is intentionally left blank Tabletop, overhead mounting methods Installation of Display UnitMounting considerations Tabletop, overhead mounting of display unit Mounting procedureTabletop, overhead mounting Flush mounting Flush mounting of display unitInstallation of Antenna Unit How to assemble the connectorDisplay unit, rear view Power cableConnecting the power cable to the battery Extending antenna cable length Antenna unitGround Extension cable line-up in case of 15 m, 30 m or 50 m Waterproofing connectorWaterproofing connector Cable extension CP20-01700, CP20-01710How to attach the N-P-8DFB connector Fabrication of coaxial cableOutput format window Port Nmea SettingNmea port Dgps port RTCM104 OutputOutput Data Sentences Select sentence windowAnt. height window Antenna HeightInput/Output data sentences Dgps Setting DGPS/WAAS options windowBeacon frequency window Beacon baud rate windowGR-7000A-1650-10N-019 GR-7000A-1650-15N-019SRemoving cover assembly DisassemblyProcedure Chassis assembly Installation of beacon receiverDismounting chassis assembly Installation of Dgps beacon receiver Connecting the coaxial cables in GR-7000AWiring the Cable assembly Attaching cable tieAttaching chassis assembly Remounting the coverChecking the beacon receiver Memory, I/O Test DisplayThis page is intentionally left blank ＰａｃｋｉｎｇＬｉｓｔ GP-1850WD（E019 GP-1850WD（E 工事材料表 20AG-X-9405 Page Page Feb Feb Page Page 指示器 Page 00080936710