Furuno GP-1850WD Installation of beacon receiver, Dismounting chassis assembly, Chassis assembly

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1850W)

Installation of beacon receiver

Procedure

1.Dismount chassis assembly from panel/chassis assembly by disconnecting the connector and PH8P from J8 on MAIN Board shown in the figure below.

Remove two ties (CV-100).

Chassis assembly

PH8P

Connector

Panel assembly

Dismounting chassis assembly

2.Dismount heat sink from chassis assembly by unfastening three screws on the ANLG board, loosening a screw at TR fixing plate and disconnecting the connector of the mini pin coax cable.

ANLG board Screws (3 X 8), 3pcs.

Mini pin coax cable

Heat sink

TR fixing plate

Chassis assembly

17