2.2POWER CONNECTIONS
It is recommended the installation of a switch and a 5A fuse (not supplied) in the positive DC supply to the FF520.
The installation of a switch is necessary to turn On or Off the FF520. Standard Horizon recommends connection the FF520 and GPS Chart Plotter to the same switch and fused source as shown in the following images below.
2.3GPS CHART PLOTTER CONNECTIONS
The FF520 is connected to Standard Horizon GPS Chart Plotters via the TEE Cable. Refer to the following images below.
2.4TEE CABLE
If the Tee cable is too large to route through your boat, the FF520 can be opened to remove the cable for easier routing. Also if the Tee cable is not long enough cable can be added.
Rubber Gasket
Figure 2.4 - Removing Panel
Cap | Power & I/O |
| cable |
GPS
Chart Plotter
Cap cable
PCB | Panel | Grommet |
|
|
Figure 2.4a - Removing Power and Tee cables
Figure 2.4b - Reinstalling Case
Page 10 | FF520 |