TC electronic SDN BHD NDY-1 user manual Setup Example Dual Inputs

Page 8

SETUP EXAMPLE: DUAL INPUTS

In this setup, we utilize the NOVA Dynamics’ auto-sensing inputs to connect two guitars at the same time. This allows for individual level calibration of the inputs, which is a great advantage if e.g. you want to use two guitars which have very different output levels due to different pick-up configurations. This might be the case if there are passive single coils on one guitar and active humbuckers on the other. Furthermore, you save an A/B switch in your setup.

• Connect two guitars to the inputs A and B of the NOVA Dynamics.

• Connect output A of the NOVA Dynamics to the input of your amp.

• Be sure to turn down the volume potentiometer on the guitar not currently in use.

Note: For best signal to noise ratio, calibrate your guitars individually. For further information, refer to this manual’s “Calibration” section.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents NDY Nova Dynamics Page Table of Contents Introduction Nova Dynamics Contents Under PressureNova Dynamics Features Setup Example Mono + Dual Processing Setup Example Single Input Dual Output Setup Example PRE & Post Processing Setup Example Dual Inputs Overview Ratio /relPower On/Off SwitchesOperation Input JacksAttack ThresholdLevel 11 + 14 Algorithm RatioMeter Clipping indicators 12 + 15 Dry/BlendSuggested Settings Compressor Suggested SettingsNoise Gate Basics Dry Blend function in the Noise Gate DampRelease Operation & Suggested Settings Noise Gate simple setup procedureNoise Gate Suggested Settings 13 A/B toggleManual Calibration Input Level CalibrationAutomatic Calibration Technical Specifications Analog Inputs Environment
Top Page Image Contents