TC electronic SDN BHD NDY-1 user manual Setup Example Mono + Dual Processing

Page 5

SETUP EXAMPLE: MONO + DUAL PROCESSING

In this setup, the two engines can be used individually or serially. You can use two compressors, two noise gates, or one of each at the same time.

• Connect your guitar to input A of the NOVA Dynamics.

• Connect output A of the NOVA Dynamics to the input of your guitar amp.

• Activate engine A and/or B and select the desired compression type and/or noise gate algorithm.

• That’s all!

Note: For best signal to noise ratio, calibrate the pedal according to the level of the input signal. For further information, refer to this manual’s “Calibration” section.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents NDY Nova Dynamics Page Table of Contents Introduction Nova Dynamics Contents Under PressureNova Dynamics Features Setup Example Mono + Dual Processing Setup Example Single Input Dual Output Setup Example PRE & Post Processing Setup Example Dual Inputs Ratio /rel OverviewOn/Off Switches PowerOperation Input JacksAttack ThresholdLevel 11 + 14 Algorithm RatioMeter 12 + 15 Dry/Blend Clipping indicatorsCompressor Suggested Settings Suggested SettingsNoise Gate Basics Dry Blend function in the Noise Gate DampRelease Noise Gate simple setup procedure Operation & Suggested SettingsNoise Gate Suggested Settings 13 A/B toggleManual Calibration Input Level CalibrationAutomatic Calibration Analog Inputs Environment Technical Specifications
Top Page Image Contents