Sprayer Software Setup | V1.98 21/06/06 |
|
|
4.0GPS
Figure 28: Options- GPS page
Note: the GPS Page is only displayed when Guidance and OR ‘Variable Rate Control’ (VRC) is selected with ‘Spray Rate Control’, when selected from the ‘ZYNX X20 Product’ screen . Otherwise the ECU page will be the first page.
Auto Section Control (ASC)
‘Auto Section’ can only be selected when a DGPS is used in conjunction with ZYNX Guidance. This feature will automatically switch sections on the sprayer, ON and OFF, therefore preventing the sprayer from overlapping or under lapping previously sprayed areas. The ASC option in ZYNX Guidance, ‘General Setup’ must also be selected.
To use ASC select the ‘Enabled’ option. Otherwise select ‘Off’
VRC/Logging Mode
Select ‘Off’ if not using VRC or Logging.
Note: When ‘Logging Only’ and ‘VRC and Logging’ are selected then the ‘VRC/Logging Synchronization’ window will be displayed. The only difference between ‘Logging Only’ and ‘VRC and Logging’, is when ‘Logging Only’ is selected the ‘VRC Master’ button is removed from the Guidance screen, to prevent confusion. When selecting ‘Logging Only’ and ‘VRC and Logging; ‘Variable Rate Control’ (Maplink VRC) must be selected in the ZYNX Product Selection screens during Startup.
Select ‘Logging Only’ if not loading a VRC prescription map but logging the sprayrates or elevation mapping using the Maplink VRC software. This allows logging to be done without loading a VRC prescription map.
Select ‘VRC and Logging’ if using the Maplink VRC software, to load a VRC prescription map to control the sprayrates to a region based map. A ‘VRC Master’ button will be displayed on the Guidance and Maplink VRC screens.
Page 46
