Setup Options -Switches

V1.98 21/06/06

 

 

8.0SWITCHES

Figure 36: Options- Switches page

Note: If ‘Enabled’ is selected on any of the 3 options then the equivalent ‘Working Screen’ options become disabled, and all three options can only be operated by the ‘External Switch Box’ (A1268) or other external switches.

External Master Switch

The External Master Switch switches all sections ON or OFF that are switched ON.

Select Enable if one of the following is connected to the ‘Spray ECU’ or ‘Sprayrate Interface’:

1.The Sprayer Switchbox (A1268) is connected to the Spray ECU marked ‘SWITCHBOX’

2.An External Master Switch (A601) is connected to the spray controller marked ‘MASTER SWITCH’ (KEE Sprayrate Interface ONLY).

3.An External Master Switch is connected to the Spray ECU and is connected to either ‘CONNECTOR 1’ or ‘CONNECTOR 3’ on the Tractor looms or Spray ECU adaptor

harness. (Spray ECU Only).

Select Disable if NO External Master Switch is connected to the Spray Controller.

External Auto Switch

The ‘External Auto Switch’ switches the sprayer mode between AUTOMATIC or MANUAL.

Select Enable if one of the following is connected to the ‘Spray ECU’ or ‘Sprayrate Interface’:

1.The KEE Switchbox (A1268) is connected to the controller box marked ‘SWITCHBOX’

2.An Auto/Manual switch is connected to ‘CONNECTOR 2’ harness on the Spray ECU. Select Disable if NO AUTO/MANUAL Switch is connected to the Spray Controller.

External Section Switch

The ‘External Section Switch’ switches the boom sections ON or OFF.

Select Enable if one of the following is connected to the ‘Spray ECU’ or ‘Sprayrate Interface’:

1.The KEE Switchbox (A1268) is connected to the controller box marked ‘SWITCHBOX’

2.If remote section switches are connected to the Boom Sensing pins on ‘CONNECTOR 2’ harness on the Spray ECU.

Select Disable if NO External Section Switches are connected to the Spray Controller.

Page 60

Page 60
Image 60
Topcom X20 manual Options- Switches