REMOTE CONTROL PANEL
Use the 5 Amp setting for small genera- tors, or for charging deeply discharged batteries.
Dip Switch Status
You can check the position of the dip switches by quickly cycling the power switch OFF/ON twice. The DC Volts bargraph will cease to display battery voltage and will indicate the settings of each dip switch. In this mode the bottom LED will illuminate if switch 1 is on; the second LED will illumi- nate if switch 2 is on, etc. Dip switch set- tings are indicated for 10 seconds after which time the display returns to indicating battery voltage.
Factory default settings for all dip switches are in the Off position.
Remote Control Wiring
The remote control panel is supplied with 25 or 50 ft. of telephone cable. The cable supplied may be 6 conductor, how- ever, only 4 conductor is required. You may buy standard 4 conductor telephone cable and run up to 50 ft., if desired. Use only a single length of telephone wire, do not splice.
Refer to page 11 for the Dip Switch
Programming chart.
9
