Xantrex Technology 2500, 2000 owner manual STATUS LEDs, Status LED, Purpose

STATUS LEDs

Status LED	Purpose
INV/CHRG	Power on light. It will be illuminated whenever the
	power switch is on (inverter on) or when there is
(Inverter/Charg
	incoming AC power and the charger comes on.
	Illuminates when incoming AC power has been
AC Input	applied and the transfer relays have engaged.
	There is a 7-12 second delay from the time the AC
	is applied and this LED illuminates.
Steady	Indicates an over-temperature condition, the unit is
Overload	shut down. It will reset automatically after cooling.
	Inverter mode- Shutdown, diagnose problem using
Blinking	DC Amps bar graph. Charger mode- Thermal
Overload	shutdown, after cooling reset by cycling power
	switch.
	This is a High/Low Battery warning condition.
Steady Battery	Inverter mode: Battery > 15.25 or < 10.50 volts
	Charger mode: Battery > 15.25 or < 10.00 volts
	Indicates either a shutdown or equalizing.
	Battery > 15.50 volts, will auto-reset at 15.25.
Blinking	Inverter mode: Battery < 10.00 volts, will auto reset
	at charger float voltage or upon AC input.
Battery
	Charger mode: Battery < 8.00 volts for 1 minute,
	remove all DC loads and manually reset by cycling
	thedisconnectingpower switchand. reapplying shorepower.

10

90-0115-00

10/97 Fltman.pm65