How to use this Manual | V1.98 21/06/06 |
|
|
HOW TO USE THIS MANUAL
All operators who have a Spray ECU installed must read the following page: Section 1.0 ‘For all Installations and Servicing of Spray ECU’s’.
Upgrading the ZYNX Spray Rate Control Software
If the ‘Spray Rate Interface’ or ‘Spray ECU’ is already installed and you are using this book to upgrade the ZYNX Sprayrate Control software to a later version, then go to straight to Section 3.0 ‘Configuration Setup’.
Installation of the Spray ECU
1.Read Section 1.0 ‘For all Installations and Servicing of Spray ECU’s’ before attempting any installations
2.Section 1.1 has details about installing the Spray ECU controller, Power/Comms harness and KEE Sprayer Switchbox.
3.Then select one of the following installations, depending on which Spray ECU kit was purchased:
3a. Section 1.2: Installing a complete KEE Spray ECU 30S kit. This section explains how to install the following: Tractor harness, Sprayer Harness, Valve Harness, wheel sensor kit, flow sensor kit, connect to a regulating valve, electronic pressure sensor and connect to a dump valve.
3b. Section 1.3: Installing a Spray ECU 30S kit to an existing KEE MK5 Spray controller or KEE Spray Rate Interface.
3c. Section 1.4: Installing the 10SR Spray ECU to existing Raven 4xx, 6xx, 4400 and 4600 series controllers. The Spray ECU 10SR has been pinned to allow direct replacement of some of the Raven 4xx, 6xx, 4400 and 4600 series controllers.
4.This section connects the Spray ECU to the battery. The hardware installation is complete.
5.Once the Installation is complete then go to Section 2.0 ‘Getting Started’. Go to Section 2.1 if starting an X15 Console OR to Section 2.2 if starting starting an X20 Console. These sections explain starting the ZYNX Console. The manual from Section 2.3 onward will be the same whether an X15/X10 Console or X20 Console is used. Section 2.3 checks the spraying software is registered. This section gives an overview of the Sprayer Working Screen and how to ‘Navigate Around the Screen’ during setting up the sprayer software.
6.Section 3.0: ‘Configuration Setup’ explains how to load your KEE Spray kit or Sprayer from the factory configurations files loaded on the ZYNX Console, if your sprayer is listed. These configuration files contain most of the sprayer settings required to set up your sprayer. If your sprayer is listed in the Factory Configurations then you can choose to do the Quick Setup (Section 3.4) OR manually follow the manual through all the sprayer software setup options (Section 4 to 15) in the Software Setup Section.
7.(Section 4 through to 15): The Sprayer Software Setup section takes the operator through the 11 pages of the OPTIONS window to setup the sprayer.
Page 7
