Installation of Spray ECU 30S KEE Sprayer Kits

V1.98 21/06/06

 

 

Installation of a Shaft/Speed Sensor kit to a tail shaft

1.On a tray mounted sprayer the Shaft/Speed Sensor Kit can used to read from the vehicle tail-shaft. Refer to Figure 9. Using the Hose Clamp or other suitable means securely mount the Magnet Block on the flange between the transmission housing and the tail shaft. Note: Do not attach the Magnet Block directly to the tail shaft as its position changes through its rotation. The Wheel Stud Magnets are not used in this case.

2.Using an existing bolt on the transmission housing and the supplied Mounting Brackets or other suitable means, securely mount the Shaft/Speed Sensor so it squarely faces the Magnet Block with a clearance of 2 to 3mm (1/16 to 1/8 inch).

3.Ensure that the Shaft/Speed Sensor is firmly attached and protected so that it cannot be damaged by wire or stones. If necessary cover the Shaft/Speed Sensor with a plate.

4.Use the 3-pin Weather Pack Extension provided if required, connecting the Shaft/Speed Sensor to the Ground Speed connector on the Tractor Harness or Sprayer Harness.

Figure 9 : Shaft/Sensor Sensor installation a tail shaft

Using an existing radar speed sensor for ground speed

1.An optional Radar Sensor Interface Harness (A449 - not provided as part of this kit but may be ordered separately) allows direct connection to any existing radar speed sensor on the tractor.

2.Connect the Radar Sensor Interface Harness to the Ground Speed connector on the Sprayer Harness or Tractor Harness then connect this wire to the signal wire from the radar sensor (not provided) to enable the Spray ECU to read the speed. Note: Check the radar sensor manufacturer's manual before attempting connection. Use the Extension Harness provided if required connecting the radar sensor to the Ground Speed connector on either the Sprayer Harness or Tractor Harness.

Page 18

Page 18
Image 18
Topcom X20 Installation of a Shaft/Speed Sensor kit to a tail shaft, Using an existing radar speed sensor for ground speed