
Configuration Setup | V1.98 21/06/06 |
|
|
Major Topic Heading
3.3 FACTORY CONFIGURATION
The ‘Factory Configuration’ button allows selection of KEE Sprayer kits or Listed Sprayers
1)Select ‘Factory Configurations’ button. A ‘Select File’ window will be displayed, as displayed below. Check to see whether your Sprayer or KEE Sprayer kit is listed here.
2)If your sprayer is not listed then go to ‘Point 3’. If your sprayer is listed then go to ‘Point 5’.
3)Select the ‘CANCEL’ button. This will close the ‘Select File’ window.
4)Then go to Section 3.5.
Showing the
highlighted
A2786-DL15S-ST
option
Figure 26: Highlighted sprayer
5)Select the sprayer by touching the name of the ‘Sprayer’, this will highlight the sprayer. The above example is shown
6)Press the ‘SELECT’ button to load the sprayers configuration.
7)A window will appear confirming that the sprayer selected will be loaded. Select the ‘YES’ button, to load the settings for the selected sprayer.
OR Select the ‘NO’ button to stop loading the selected sprayer.
If the Sprayer or Sprayer Kit was listed and selected then the Sprayer Configuration will be loaded. The current Sprayer or Sprayer kit will be displayed, the ‘(Factory)’ after the Sprayer name, as shown below, indicates the Sprayer was loaded from the ‘Factory Configurations’ list.
Showing current
Sprayer selected
Figure 27: Options- Configuration showing sprayer kit
Page 43