Wiring Connection Table for KEE Sprayrate Interface- A1237

V1.98 21/06/06

 

 

21.9 KEE SPRAYRATE INTERFACE

Master Switch

External Switchbox

Don’t Use this plug

Tractor Harness

Tractor Radar

To Console-RS232

Figure 130: KEE SPRAYRATE INTERFACE

Part Number: A1237

Firmware Version: BMS 41

ZYNX Sprayer Controller Software

1.OPTIONS/ECU/Controller: Select ‘Spray Interface’

2.OPTIONS/ECU/ECU Model: N/A

Master Switch: To use this connection connect the ‘External Master Switch’ (A601) to the plug. This closes the circuit between Pin A and Pin B.

Open circuit, ‘Master is ON’. Closed circuit, ‘Master is OFF’.

Select ‘External Master Switch’, ‘Enabled’ on the OPTIONS/Switches page, if fitting an External Master Switch to this plug.

Tractor Harness: Connect the Tractor Harness to this plug and to the tractors battery.

Tractor Radar: To utilise this plug connect the ‘Tractor Radar Adaptor Harness’ (A449) to this plug. This enables splicing to a Tractor radar input.

Note: Refer to tractor manufacturers technical data before attempting installation. Select ‘Tractor Radar’ from the ‘Speed From’ window on the OPTIONS/ECU page.

Switcbox: Connect KEE’s External Switcbox to this plug. See Section 5.0 (Switches Page) to enable the ‘External Switcbox’.

‘To Console Power’- Do not use.

‘To Console-RS232’- connect the serial communications cable from this plug to the ‘COM Port’ on the back of the ZYNX Console. Connect to the ‘COM Port’ that is selected on the OPTIONS/ECU page.

Page 148

Page 148
Image 148
Topcom X20 manual KEE Sprayrate Interface