Setup Options | V1.98 21/06/06 |
|
|
9.0SENSORS
Current Cal
Factor
Units used
Calculator Icon
Figure 40: Flow Sensor specifications page
FLOW
Note: Most Flow Sensors have a calibration factor stamped or labeled on the Flow Sensor body.The factor will be in ‘pulses per volume’, (volume can be Litres, US Gallons etc). This factor may be entered manually into the ‘Flow Sensor Specifications’ window. Make sure the correct units (volume) are selected from the UNITS page, which correspond to the units used on the Flow Sensor. If the Flowmeter Calibration is not known or the operator wants to check the Calibration Factor, the Calibration procedure must be used from the ‘Working Screen’, see Section 17.8.
Calibration Factor
Select the Tank (1,2 or 3) the using the ‘Arrows’, (normally ‘Tank 1’).
Select the ‘Sensor Specifications’ button, a ‘Flow Sensor Specifications’ window will appear. Using the Screen Calculator type in the Flow Sensor Calibration, don’t forget the decimal point if required. Select ‘Enter’ to accept and save the factor.
The current ‘Calibration Factor’ is displayed and the current units displayed in ‘blue’.
Note: If typing in a Flow sensor calibration for a Raven Flow sensor then divide the factor by 10 before entering the factor, (Raven label says ‘187’; then type ‘18.7’ into the ‘Flow Sensor Specifications’). This is because the Raven console does not have decimal points and assumes the last digit is a decimal place.
Select
Minimum Flow (Flow Meter)
Enter the ‘minimum flow’ of the Flow Meter fitted to the sprayer. Every Flow Meter has a minimum value which below this point, it can not control accurately. Therefore when the Flow Meter reaches this value, the regulator valve will not attempt to control below this minimum value, it will hold the regulator valve at that point. Then the ‘Flow’ readout will display a red indicator alerting the operator of this. Then select the ‘Flow’ readout and an explanation will be displayed in the Flow window.
This is because the ‘red’ indicator can mean ‘Minimum Flow’ (Flow Meter) or ‘Minimum Nozzle Flow’.
Page 65
