Kawai CN22 manual Assembly Instructions, „ Parts Provided

Page

34

2) ASSEMBLY INSTRUCTIONS

Caution y Ensure that this section is read thoroughly before attempting to assemble the CN22 digital piano, and that two or more people work on unit assembly.

yWhen moving the CN22 digital piano, ensure that hands are not caught in the unit, and that the piano is not dropped on an individual’s feet.

Before attempting to assemble the CN22 digital piano, ensure that all parts are included.

A Phillips-head screwdriver will also be required to assemble the unit (not included).

„ PARTS PROVIDED
Side Panel (A)	2 pcs.
Back Panel (B)	1 pc.
Pedal Board (C)	1 pc.
Screw (D)	2 pcs.
Screw (E)	4 pcs.
Screw (F)	10 pcs.
Bolt (with plain washers and
spring washers) (G)	4 pcs.
Adjuster (H)	1 pc.
Headphone hook set
x Headphone hook	1 pc.
x Tapping screw	2 pcs.

Screw (D)	Screw (E)	Screw (F)
ø4 ° 30	ø4 ° 20	ø4 ° 14

Bolt (G)	Adjuster (H)
M6 ° 25

„ASSEMBLY SEQUENCE

1.Insert the Adjuster (H) approximately 1 cm into the bottom of the Pedal Board (C).

Untie and extend the connection cord from the Pedal Board. Loosely fasten the left and right Side Panels (A) to the Pedal Board (C) using a single short screw (F) for each side. After ensuring that the correct Side Panels are used for the left and right side, and that the pedal cable is not caught between the assembled parts, securely fasten the Side Panels to the Pedal Board using an additional four short screws (F) on each side.

Arrow

(F’)

(C)

(A)	Pedal cable	Pedal support insert hole
		(back of the pedal board)

(F)

(H)

6 APPENDICES

2.Fasten the Back Panel (B) to the left and right Side Panels (A) using a single long screw (D) on either side.

Then, fasten the Back Panel to the Pedal Board using four medium screws (E).

(A)

(D)

(C)

(E)

(B)