Page
35
Step4
Start to play the piano.
The recorder will automatically start recording with the fi rst note played.
During this time, the LED indicators for the REC and PLAY/STOP buttons will be turned on.
Any changes made to the sound while recording will also be recorded.
The recording can be started by pressing the PLAY/STOP button instead of pressing a key, allowing a blank bar to be inserted at the beginning of a song.
Step5
Press the PLAY/STOP button to stop recording.
The LED indicators for the PLAY/STOP button and the REC button will turn off and the newly recorded part will be saved to memory automatically.
Saving may take a few moments and during this time the piano will not perform any other operations.
To record the piece again, simply repeat the above procedure.The new recording will completely erase the previous one.
The total recording capacity of the CN41 piano’s memory is approximately 15,000 notes, with button and pedal presses also counted as one note.
When the maximum capacity is reached, recording will stop and all music recorded up until that point will be saved to memory automatically.
Performance data stored inside the CN41 piano’s memory will be saved even after turning off the power. Panel operations stored during recording:
xChanges made to the sound type.
xShifts between DUAL and SPLIT modes. Panel operations NOT stored during recording:
xChanges made to effect settings – the selected effect will be applied to the selected sound type.
xChanges made to tempo.
xChanges made using the BALANCE slider in DUAL or SPLIT modes – the volume balance set immediately before recording will be stored, however.
xTurning the TOUCH CURVE or TRANSPOSE functions ON or OFF – regardless of the transpose settings the performance will be replayed at the pitch originally used for the recording.
RECORDER
4