sectionAssembly Instructions (CA63 only)
Please read these assembly instructions thoroughly before attempting to assemble the CA63 digital piano.
Please ensure that two or more people work on assembling the CA63 digital piano, especially when lifting the main body of the instrument onto the stand in step 3.
Included parts
Before attempting to assemble the CA63 digital piano, ensure that all parts below are included.
A
aMain body x 1 | bSide panel x 2 |
| (left, right) |
Screws (flat tip)
eScrew (with flat washer and spring washer) x 2
fScrew (long, black) x 2 gScrew (short, black) x 4
Screws (pointed tip)
hTapping screw (long, black) x 4 iTapping screw (short, silver) x 4
jWasher x 2 kCable clamp x 2 lPower cable x 1
| mHeadphone hook set x 1 | |
cPedal board x 1 | dBack board x 1 | Mounting screw x 2 |
Pedal support bolt x 1 | Headphone hook x 1 | |
|
|
1. Assembling the side panels b, pedal board, and pedal support bolt c
Unfasten and extend the pedal connection cable attached to | b |
the bottom of the pedal board c. |
|
Insert the pedal support bolt approximately 1 cm into the | Pedal cable |
pedal board, using the hole shown in the diagram. | b |
Attach the pedal board c to the left and right side panels b using the temporary mounting screws located on either end
of the pedal board. Ensure that the correct side panel is used i for the left and right side.
Ensure that the pedal board and side panels make close |
|
contact, and that there are no large gaps between the | i |
assembled parts. |
|
Appendix
Insert the four short silver tapping screws i into the holes as shown, and securely fasten the pedal board to the and left and right side panels.
Ensure that the left and right side panels are securely fastened to the pedal board.
Temporary mounting screw
Pedal support bolt hole |
90