Program Change Mode
A Program Change, often referred to as a Patch Change, is a MIDI message
from one device to another that causes the latter to switch to a new program.
Using Program Change messages, MPK261 can tell another hardware or software device which sound to play. For example, if your MPK261 is controlling a piano patch in your software or an external MIDI device, sending a
Program Change message from MPK261 causes it to switch to a synth patch.
MPK261 lets you send two types of Program Change messages:
•Program Change: This is a standard Program Change message
•Program Change with Bank Change: This is a standard Program Change message (0– 127) plus a Bank Select LSB (Least Significant Bit)
To navigate Program Change Mode:
1.Press Program Change to enter Program Change Mode.
2.In each page of Program Change Mode:
•Use the Up Cursor and Down Cursor buttons to move through the parameters on the current page.
•Use the Left Cursor and Right Cursor buttons to move between different pages.
•Turn the Value Dial to change the currently selected value/setting.
Important: These changes cannot be saved to your Presets or global settings. Once you power off the MPK261 they will return to the default settings.
Each section of this chapter is dedicated to a specific Program Change and lists its editable parameters.
For an overview of the available settings and parameters, see the Appendix: Mode Parameters section.
28