Pioneer DJM-500 Checking Accessories, Location, Condensation, Cleaning the unit

Page 4

CAUTIONS REGARDING HANDLING

Location

Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity.

Do not install the unit in a location which is exposed to direct rays of the sun, or near stoves or radiators. Exces- sive heat can adversely affect the cabinet and internal com- ponents. Installation of the unit in a damp or dusty envi- ronment may also result in a malfunction or accident. (Avoid installation near cookers etc., where the unit may be ex- posed to oily smoke, steam or heat.)

Condensation

When this unit is brought into a warm room from previ- ously cold surroundings or when the room temperature rises sharply, condensation may form inside, and the unit may not be able to attain its full performance. In cases like this, allow the unit to stand for about an hour or raise the room temperature gradually.

Cleaning the unit

•Use a polishing cloth to wipe off dust and dirt.

•When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water and wrung out well, then wipe again with a dry cloth. Do not use furniture wax or cleaners.

•Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces.

4

CHECKING ACCESSORIES

• Power cord

•Short-circuit pin plug (four)

These are inserted in the PHONO 1 and PHONO 2 termi- nals at the rear.

•Operating instructions

<DRB1192>

Page 3 Page 5
Image 4
Page 3 Page 5
Contents DJM-500 Pour le modèle Canadien For Canadian modelInformation to User We Want You Listening For a Lifetime Checking Accessories Cleaning the unitLocation CondensationFeatures Connecting audio cords ConnectionsConnection of Input Equipment DJM-500Connection of Outputs, Microphones, Etc Master level attenuator knobName and Function of Parts Front sectionMain Microphone Terminal and Microphone Control Knob Power Supply Switch PowerEffector Parameter/BPM Display Refer to = Headphone Terminal Phones ~ Channel Fader Volume Assign Switch Assign A, B@ Fader Start Switch Fader Start Refer to # Cross Fader Volume Cross FaderRear section Using the Effect Function Features of Various EffectorsDelay one repeated sound Auto BPM Counter Auto BPM CounterEcho repeated sounds Auto Pan L-R BalanceFlanger Pitch ShifterMeasuring BPM Press CH2 of the monitor selector auto BPM counter selectorOperating Delay, Echo, Auto pan, Flanger Set the parameter value with the parameter knob delay timeTurn on the effect switch Precautions for Effect FunctionUsing the External Effector Set the parameter value pitch % using the parameter knobOperating Pitch Shifter and Reverb Set the parameter of the external effector, etcUsing the Fader Start Function Turn off the cross fader switchStarting the Cross Fader Starting the Channel fader Fader Start PlayTroubleshooting Replacement of Cross Fader Volume ControlSpecifications AccessoriesAudio Section Electrical Section, Others95I00ZZ0C00
Top Page Image Contents