Important Safety Rules, Installation | Cabela's 08-0901 specification

IMPORTANT SAFETY RULES

READ AND FULLY UNDERSTAND ALL INSTRUCTIONS

AND WARNINGS PRIOR TO USING THIS UNIT. YOUR

SAFETY IS MOST IMPORTANT! FAILURE TO COMPLY

WITH PROCEDURES AND SAFEGUARDS MAY RESULT WARNING! IN SERIOUS INJURY OR PROPERTY DAMAGE.

REMEMBER: YOUR PERSONAL SAFETY IS YOUR

RESPONSIBILITY!

1. DO NOT use the grinder and the Foot Pedal			position before attaching to the power source.
without the grinder properly set up in accordance to			11. NEVER LEAVE THE GRINDER AND
the manufacturer’s guidelines.
			THE FOOT PEDAL UNATTENDED.	Be safe,
2. Using the Foot Pedal on grinders without			DISCONNECT the grinder and the Foot Pedal
proper point of operation measures and protection			from power source before leaving the work
can cause serious injury.	Follow the	grinder’s	area. Close supervision is necessary when any
manufacturer safety guidelines. DO NOT use the			appliance is used near children. This appliance is
Foot Pedal on grinders without proper installation.			NOT to be used by children.
3. The Foot Pedal should be utilized so that			12. TIE BACK loose hair and clothing, and roll
the operator’s hands and fingers cannot enter			up long sleeves before operating the grinder and
dangerous areas of the grinder. KEEP FINGERS			the Foot Pedal. REMOVE ties, rings, watches,
CLEAR of the Auger and Cutting Blades AT ALL			bracelets, or other jewelry before operating the
TIMES. NEVER REACH INTO THE GRINDER,			grinder and the Foot Pedal.
doing so may cause serious injury.		ALWAYS	13. Be sure the grinder is on a stable work
USE THE PROVIDED STOMPER, NEVER FEED
FOOD BY HAND. NEVER use fingers to scrape			surface. Be sure all the grinder feet are stable.
food away from the Grinding Plate		while the	14. ONLY use the Foot Pedal with shoes on.
Grinder is in operation. SEVERE INJURY MAY
RESULT.			NEVER use the Foot Pedal with bare or stocking
4. ALWAYS DISCONNECT grinder and the			feet.
			15. The Foot Pedal may become HOT during
Foot Pedal from power source before servicing,
changing accessories, plates or knives or cleaning			operation. This is normal. DO NOT touch the
the unit.			Foot Pedal parts during operation or until they cool
5. Plug the grinder and the Foot Pedal into a			after use.
			16. ONLY use the Foot Pedal on hard, flame-
standard 120 Volt, 60 Hz wall outlet.
			resistant surfaces. DO NOT use the Foot Pedal
6. DO NOT USE the grinder and the Foot Pedal			on carpeted surfaces.
if the Power Cord, Plug	or any other parts are		17. Keep the area around the Foot Pedal clear
damaged. If the Power Cord, the grinder or the
Foot Pedal are damaged, call Customer Service.			of all objects to avoid accidental ignition. NEVER
DO NOT ATTEMPT TO REPLACE THE CORD.			place an object on the Foot Pedal to keep the

INSTALLATION

WARNING! Before attaching or detaching the Foot Pedal to the grinder, make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE and the power switch is in the OFF position. ALWAYS unplug the Foot Pedal and the grinder when not in use. ALWAYS FOLLOW THE MANUFACTURER’S INSTRUCTIONS AND SAFETY GUIDELINES THE COME WITH THE GRINDER AND THE FOOT PEDAL.

1.Be sure the power switch on the grinder is in the ‘OFF’ position.

2.Plug the power cord on the grinder into

the back of the plug on the Foot Pedal.

3.Plug the Foot Pedal into a 110 Volt electric outlet.

4. Turn the switch grinder switch to the ‘ON’ position.

5.The grinder will not operate until the Foot Pedal is depressed with your foot.

6.To stop the grinder, release the pressure on the Foot Pedal by raising your

foot.

GROUNDING INSTRUCTIONS


Be sure to not allow the Power Cord to drape into		grinder running.			The Foot Pedal is intended for
your work area. Check that all parts are operating		intermittent grinding and stuffing.
properly, and perform the intended functions.		18.	This product is not intended for commercial
Check for alignment of moving parts or any other
conditions that may affect the operation. DO NOT		use.	Commercial use will void the warranty.
use extension cords.		19.	WEAR EYE PROTECTION.			Wear safety

7. NEVER use any accessories or parts from		glasses.		Everyday eye glasses are not safety
other manufacturers. Doing so will VOID YOUR		glasses.		Safety glasses conform to ANSI Z87.1
WARRANTY and may cause fire, electrical shock		requirements.			Note: approved	safety glasses
or injury.		have Z87 printed or stamped on them.
8. TO PROTECT AGAINST RISK OF		20.	DO NOT use outdoors.
ELECTRICAL SHOCK: DO NOT SUBMERGE		21.	The Foot Pedal is intended for use with
THE GRINDER OR THE FOOT PEDAL INTO
WATER OR LIQUID. BE SURE THE GRINDER		Grinders ONLY.
AND THE FOOT PEDAL ARE DISCONNECTED		22.	DO NOT use the grinder and the Foot Pedal
FROM THE POWER SOURCE BEFORE
CLEANING. DO NOT use near water or liquids.		while under the influence of drugs, medications or
9.	Be sure the Foot Pedal is on the, clean, dry floor.	alcohol.
		23.	DO NOT let the Power Cord hang over edge

10.	Reduce risk of unintentional starting. Make	of work surface during operation.

sure the power switch of the grinder is in the “OFF”

SAVE THESE INSTRUCTIONS!

Refer to them often and use them to instruct others.

GROUNDING

This appliance must be grounded while in use to protect the operator from electrical shock. The appliance is equipped with a 3-conductor cord and a 3-prong grounding type plug to fit the proper grounding-type receptacle. The appliance has a plug that looks like Figure A. An adaptor, Figure B, should be used for connecting Figure A plugs to two-prong receptacles. The grounding tab which extends from the adaptor must be connected to a permanent ground such as a properly grounded outlet box as shown in Figure C using a metal screw.

Cabela's 08-0901 manual Important Safety Rules, Installation, Grounding Instructions