Nady Systems W1KUHTBAND1 System Operation, Buttons Function, Rack-mounting the Receiver

System Operation

W-1KU Receiver

Buttons Function

The Power Button (12) is used to turn the receiver on or off. When the button is pressed, the lit blue backlight on the LCD Display (2) indicates the receiver is on. Press the Power button again to turn off the receiver. The backlight on the LCD will turn off indicating the receiver is off. At power-off the W-1KU receiver will store the last settings entered and re-display them at power-on. It can be reprogrammed to any new Group/Channel, or Volume level. The default factory setting is Group 08, Channel 00, and Volume 63.

When the Set Button (8) is repeatedly pressed the LCD main menu will cycle in this order:

MAIN MENU > VOLUME > GROUP > CHANNEL > repeat

The selected function will flash for 20 seconds before returning to the main menu.

The (Up) or (Down) Buttons (9) are

active while in the Set mode, or can be used to change Volume Level (6) at anytime.

The IR Sync Button (11) is used to transfer the frequency-selected info from the receiver to the transmitter being used for easy synchronization prior to use. Press the IR Sync Button while the main menu is displayed, and the IR LED (10) will flash quickly. This LED indicates IR transmission is in progress. Press the SET Button again to stop the flashing or it will halt in 20 seconds automatically.

Selecting the W-1KU Receiver Volume Level / Group / Channel

See RF Interference and Finding Open Channels. This section will also aid in finding desired channel(s) of operation when setting up your system(s).

Press the (Up) or (Down) Buttons once or the Set button once prior to pressing or for single stepping through the Volume Levels (6). Or hold continuously for faster level selection. Select one of 63 levels from the Volume menu and advance to Exit Set Up Mode by pressing the Set Button (8). Choose the W-1KU operating frequency by selecting one of ten Groups (4) and one of 100 Channels (5) that are determined to be desirable open channels. Press the Set button twice to skip the volume setting and enter the Group setup mode, then press the or buttons once for single stepping through the groups. Or hold continuously for faster group selection. Select one of ten groups available from the Group menu and then advance to Channel Setup Mode by pressing the Set button. Or, press the Set button twice to exit without changing the channel. Press the or buttons three times or press the Set button again after group setting to enter the Channel setup mode. Press the or buttons once for single stepping through the channels,

or hold continuously for faster channel selection. Select one of 100 channels available from the channel menu or press the Set button again to exit.

Rack-mounting the Receiver

There are two options available for rack mounting the W-1KU: single or side-by-side with another W-1KU receiver.

Single Unit Rack Mount Kit (20): Attach the optional RMK-1KUS Rack Kit ears to each side and tighten with supplied screws.

Dual Unit Rack Mount Kit (21): Attach the optional RMT-1KUD Dual Receiver Rack Tray to bottom of both receivers and tighten with supplied screws.

Note: Do not mount the receiver on a rack directly above an amplifier or other source of high heat. This could degrade the performance of the W-1KU. Always ensure adequate airflow and heat dissipation in any rack configuration.

8