UB-10 BODYPACK TRANSMITTER
1.Slide open the hinged BATTERY COMPARTMENT (18) and insert a fresh 9V ALKALINE BATTERY (19), observing the correct polarity. A fresh alkaline battery can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended that the battery be replaced after
2.The
INSTRUMENT (for guitar, bass, etc.)/ HEADWORN MIC/ LAVALIER MIC.
3.The
4.Turn on the
5.Instrument Use
Plug the 1/4" phone plug from the INSTRUMENT CORD (22) into the instrument. As the cord to the instrument also serves as the antenna, be sure to extend it fully for maximum range. Rolling up or shortening the cord may reduce the effective operating range. When ready to play, slide the audio OFF/STANDBY/ON SWITCH (25) to the ON position. Adjust the volume of the receiver as per the Audio Output Instrument Connections section of the above UHF 10 receiver instructions.
7
(Note: The INPUT LEVEL CONTROL (27) is deactivated and not used when the
The AF PEAK LED INDICATOR (3) on the UHF 10 receiver will light for all loud input signals. Occasional flickering on and off during use is normal, however if the LED stays on continuously, turn down the instrument volume or noticeable distortion may result.
(Note: Scratchy noises can sometimes occur when some electric guitars with dirty pots or connections are used with any wireless system. There fore, the supplied INSTRUMENT CORD (22) has a factory installed capacitor inside the 1/4" plug. This capacitor provides first order filtering of the RF signal from the cord into the guitar and eliminates virtually all scratchy noises. Should your equipment still give you scratchy noises, we suggest these steps to eliminate them:
1)Make sure all guitar volume and tone pots are clean and all contacts are
2)A 47pf capacitor soldered across the hot to ground terminals of the guitar's volume and tone pots will provide extra filtering.)
6.Microphone Use (with either a lavalier or headworn microphone) Secure the connection from the LAVALIER (24) or HEADWORN MIC CORD (23) by turning the slip ring on the plug into the transmitter clockwise to thread it on to the jack. To unplug, reverse the process. To use the lavalier mic, attach it at chest level. Do not place it too close to the
When ready to speak, slide the OFF/STANDBY/ON SWITCH (25) to the ON position. Adjust the volume of the receiver as per the Audio Output Microphone Connection section of the above UHF 10 receiver instruc-
8