Pioneer VSX-LX52 Controlling the rest of your system Chapter, Operating multiple receivers

Controlling the rest of your system 09

Chapter 9:

Controlling the rest of your system

Operating multiple receivers

The remote control included with this receiver can be used to operate up to three other receivers (of the same model as this receiver) in addition to this receiver. The receiver to be operated is switched by inputting the preset code to set the remote control setting.

•Set the remote modes on the receivers before using this function (see Remote Control Mode Setup on page 90).

		HDMI OUT	AUDIO INFO	CH
1	2	3
			DISP
SIGNAL SEL	MCACC	SLEEP	TV CTRL	RECEIVER
4	5	6
SBch	A.ATT	DIMMER	REMOTE
7	8	9	SETUP
D.ACCESS	CH LEVEL	CLASS	ZONE 2	ZONE 3

0 ENTER MAIN

1Check the operation selector switch to MAIN.

2Press RECEIVER .

3Press and hold REMOTE SETUP, then release it after the LED flashes twice.

4Use the number buttons to enter the 5-digit preset code (see below).

•Receiver 1: 6 1 9 3 5 (Default)

•Receiver 2: 6 2 6 3 0

•Receiver 3: 6 2 6 3 1

•Receiver 4: 6 2 6 3 2

When the preset code is fully input, the LED flashes once to indicate that the setting is completed.

To operate another receiver, start over from step 1 to input its preset code.

Setting the remote to control other components

Most components can be assigned to one of the input function buttons (such as DVD or CD) using the component’s manufacturer preset code stored in the remote.

However, there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using.

Note

•You can cancel or exit any of the steps by pressing RECEIVER . To go back a step, press RETURN.

•After one minute of inactivity, the remote automatically exits the operation.

Selecting preset codes directly

1Press the input function button for the component you want to control.1

When assigning preset codes to TV CONTROL, press TV CTRL here.

2Press and hold REMOTE SETUP, then release it after the LED flashes twice.

3Use the number buttons to enter the 5-digit preset code.

See Preset code list on page 105.

When the preset code is fully input, the LED flashes once to indicate that the setting is completed.

4Repeat steps 1 through 3 for the other components you want to control.

To try out the remote control, switch the component on or off (into standby) by pressing  SOURCE. If it doesn’t seem to work, select the next code from the list (if there is one).

Note

1 You can’t assign

RECEIVER , TUNER or iPod/USB.

67

En