Pioneer VSX-LX52 manual Advanced Mcacc menu, Microphone.1

The Advanced MCACC menu 10

2nd reference	3rd reference
point	point
1	2

3

Main listening

position

3Connect the microphone to the MCACC SETUP MIC jack on the front panel.

•Push down on the PUSH OPEN tab to access the MCACC SETUP MIC jack.

Make sure there are no obstacles between the speakers and the microphone.

		MASTER
CONTROL	ON/OFF	VOLUME
		VIDEO CAMERA
	iPod
	iPhone
MCACC SETUP MIC	USB	HDMI 4

6Wait for the Auto MCACC Setup to finish outputting test tones.

A progress report is displayed on-screen while the

receiver outputs test tones to determine the speakers present in your setup. Try to be as quiet as possible while it’s doing this.

•Do not adjust the volume during the test tones. This may result in incorrect speaker settings.

•With error messages (such as Too much ambient noise! or Check microphone) select RETRY after checking for ambient noise (see Problems when using the Auto MCACC Setup on page 40) and verifying the mic connection. If there doesn’t seem to be a problem, you can simply select GO NEXT and continue.

7If necessary, confirm the speaker configuration in the GUI screen.2

The configuration shown on-screen should reflect the actual speakers you have.

If no operations are performed for 10 seconds while the speaker configuration check screen is being displayed, the Auto MCACC Setup will resume automatically. In this case, you don’t need to select ‘OK’ and press ENTER in step 8.

If you have a tripod, use it to place the microphone so that it’s about ear level at your normal listening position. If you do not have a tripod, use some other object to install the

microphone.1

1b.Auto MCACC					1b.Auto MCACC
	A/V RECEIVER				A/V RECEIVER
Now Analyzing...	2/10		L	:	YES
			C	:	YES
Environment Check			R	:	YES
			SR	:	YES
Ambient Noise	: OK		SBR	:	YES
Microphone	:		SBL	:	YES
Speaker YES/NO	:		SL	:	YES
			SW	:	YES
			10
			OK		RETRY
Exit		Cancel	Exit		Cancel

4When you’re finished setting the options, select START then press ENTER.

5Follow the instructions on-screen.

•Make sure the microphone is connected.

•If you’re using a subwoofer, it is automatically detected every time you switch on the system. Make sure it is on and the volume is turned up.

•See Problems when using the Auto MCACC Setup on page 40 for notes regarding high background noise levels and other possible interference.

•If you see an ERR message (or the speaker

configuration displayed isn’t correct), there may be a problem with the speaker connection.

If selecting RETRY doesn’t work, turn off the power

and check the speaker connections. If there doesn’t seem to be a problem, you can simply use / to select the speaker and / to change the setting and continue.

•If Reverse Phase is displayed, the speaker’s wiring

(+ and –) may be inverted. Check the speaker connections.3

–If the connections were wrong, turn off the power, disconnect the power cord, then reconnect properly. After this, perform the Full Auto MCACC procedure again.

–If the connections were right, select GO NEXT and continue.

Note

1It may not be possible to measure correctly if the microphone is placed on a table, sofa, etc.

2This screen is only shown if you selected ALL or Speaker Setting from the Auto MCACC menu.

3If the speaker is not pointed to the microphone (listening position) or when using speakers that affect the phase (dipole speakers, reflective speakers, etc.), Reverse Phase may be displayed even if the speakers are properly connected.

73

En