GFX2200HT GUITAR AMPLIFIER
The Rear Panel:
EFFECTS LOOP | SPEAKERS |
| |
LINE | LINE | 160 WATTS @ 4 OHMS |
|
OUT | IN | 220 WATTS @ 2 OHMS |
|
|
| 2 OHM MIN. LOAD |
|
22 | 23 | 24 | 25 |
22.EFFECTS LOOP LINE OUT: When using an external effects processor, con- nect this jack to the input of the effect by means of a shielded signal cable. This jack also doubles as a source for a
23.EFFECTS LOOP LINE IN: When using an external effects processor, con- nect this jack to the output of the effect by means of a shielded signal cable. This jack also doubles as a direct connection to the power amp, bypassing the input and pre- amp stages. This is useful for “slaving” a pair of amplifiers together.
24.SPEAKERS: Use these jacks to con- nect the amplifier to your speaker cabi- net(s) using speaker cables with mono 1/4” plugs. These jacks are wired in parallel. Make sure that the combined impedance of your speakers is equal to or greater than 2 ohms! Use the chart below to help deter- mine parallel loads. If in doubt, ask your dealer.
CAB IMP | # CABS TOTAL IMP | |
4 ohms | 2 | 2 ohms |
8 ohms | 2 | 4 ohms |
8 ohms | 4 | 2 ohms |
16 ohms | 2 | 8 ohms |
16 ohms | 4 | 4 ohms |
16 ohms | 8 | 2 ohms |
|
|
|
25.POWER CORD: This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Don not attempt to defeat the safety ground connection.
5