Techno Tidbits and
Symptom | Cause | Remedy | |
No sound output from the surround back speakers.
•The SB CH MODE is set to OFF.
•The source is not a 6.1 channel playback source.
•The surround back speakers aren't con- nected properly.
•The surround back channel is set to 1 speaker setting only, and the speaker is connected to the right channel output.
•Set the SB CH MODE to ON or AUTO (see page 55).
•Set the SB CH MODE to ON or AUTO (see page 55) and choose one of the SURROUND listening modes (see pages 48 and 49).
•Check all connections (see page 25).
•Connect the speaker to the surround back left channel output (see page 25).
No sound output from one (set of) speaker(s).
•The speaker system setting is NO.
•The speaker isn't connected properly.
•The source has no sound output for that channel.
•The speaker output level is set too small.
•Change the speaker setting to YES (see page 41).
•Check all connections (see page 25).
•If you choose one of the SURROUND listening modes, a channel may be created for the speaker (see page 45).
•Increase the speaker output level.
Sound is produced from some components, but not from digital components.
•SIGNAL SELECT is set incorrectly.
•The digital inputs are assigned incor- rectly, or not at all.
•The digital components aren't connected properly.
•The player is not compatible with the source you're using, or the player set- tings are incorrect.
•The MULTI CH IN mode has been selected.
•The digital output level has been turned down on a CD player or other compo- nent equipped with digital output level adjustment capability.
•Set SIGNAL SELECT to AUTO or according to the type of connections made (see page 46).
•Set the digital input settings correctly (see pages 12, 23, and especially 89).
•Check all connections.
•Choose a compatible source, or check the player's manual for the correct set- tings.
•Choose one of the listening modes (see page 47). The MULTI CH IN switches off automatically.
•Set the digital volume level of the player to full, or to the neutral position.
Other audio problems
Subwoofer output is very low. • Settings route signal away from sub- woofer.
•To get more signal to the subwoofer set it to PLUS or choose SMALL for the front speakers (see page 41).
During multichannel playback, • That speaker is set to NO. there is no sound output from
one speaker.
• Set the speaker to YES.
A multi channel DVD source appears to be downmixed from 2 channels during playback.
•The source is coming from something other than the MULTI CH IN jacks (for example, digital PCM output, etc.)
•Check the MULTI CH IN connection (see page 21) and select the type of playback with the MULTI CH IN button (see page 54).
Considerable noise in radio broadcasts.
•Incorrect frequency.
•The antenna is not connected.
•Digital cables are near the antenna ter- minals and wires.
•Tune in the correct frequency.
•Connect the antenna (see page 24).
•Route digital cables away from the antenna terminals and wires.
112
En