5 minute guide
Using the Quick Setup
You can use the Quick Setup to get your system up and running with just a few button presses. The receiver automatically makes the necessary settings after you have selected your speaker setup, room size and listening position. If you want to make more specific settings, refer to Choosing your receiver setup on page 44.
Use the front panel controls for the steps below.
02
If a subwoofer wasn’t detected in step 2, you can cycle between the following choices:
2.0ch | 3.0ch |
7.0ch* | 4.0ch |
6.0ch | 5.0ch |
*
•Check the table below to find the speaker setup that corresponds with your system.
|
|
|
|
|
|
| MULTI JOG |
|
|
|
|
|
| ENTER |
|
|
|
|
|
|
|
| MASTER VOLUME |
ADVANCED | STEREO/ | SIGNAL | MIDNIGHT/ | SB CH | TONE | QUICK |
|
SURROUND | DIRECT | SELECT | LOUDNESS SPEAKERS | MODE | SETUP |
| |
PHONES SURR. |
|
|
|
|
| DOWN | UP |
|
|
|
| MULTI JOG |
| ||
LISTENING MODE |
|
|
| VIDEO INPUT |
|
| |
FL DIMMER |
|
|
|
|
|
|
|
|
|
| VIDEO | L | AUDIO R |
|
1If the receiver is off, press STANDBY/ON to turn the power on.
The STANDBY indicator goes out.
2 Press QUICK SETUP.
SW DET flashes in the display while the receiver checks your setup for a subwoofer. SW YES or SW NO confirms the subwoofer check, then the display prompts you to select your speaker setup.
3Use the MULTI JOG dial to choose your speaker setup.
When a subwoofer was detected in step 2, you can cycle between the following choices:
2.1ch | 3.1ch |
7.1ch* | 4.1ch |
6.1ch | 5.1ch |
*
*
4Press ENTER.
5Use the MULTI JOG dial to choose your room size.
Depending on the distance of your speakers from the listening position, choose between small, medium, or large (S, M or L), M being an
6Press ENTER.
13
En