AKG Acoustics DMS700 Function Description, Quick Setup, Frequency, Encryption, Mute Lock

	DMS
	700		9 Function Description
QUICK SETUP			The DSR 700 has been designed for use in large multi-channel systems. To find intermodulation-
			free and clean carrier frequencies quickly and easily, we recommend using the QUICK SETUP func-
			tion to find all required channels.
			1. To start QUICK SETUP, select the START SETUP menu, set the required number of channels as
			well as the required frequency ranges and start scanning.
			The scan procedure can take up to one minute. The CHANNEL LIST shows you clean channels
			in a user-friendly list.
			2. To assign and synchronize a clean channel to the receiver you can use the channel button.
			3. Use the CONTINUE SCAN sub-menu to search for other frequencies.
CHANNEL Menu
			All channel-specific parameters such as GROUP/CHANNEL, FREQUENCY, NAME, PT GAIN, TRANS-
	▲		MISSION POWER, ENCRYPTION and MUTE LOCK can be set and adjusted manually.
			The DSR 700 receiver provides frequency groups with specially calculated frequencies. In the
GROUP / CHANNEL
		!	GROUP/CHANNEL menu you can set and synchronize a channel (frequency) manually.
Important!
			• Make certain that all selected channels are from the same Group within the same Pre-
			set. To find clean channels we recommend using the QUICK SETUP function.
FREQUENCY			The FREQUENCY sub-menu allows frequency adjustments in 25-kHz increments.
		NAME	You can enter any name (the name of a performer or instrument, etc) for each channel.
	PT GAIN		This sub-menu allows you to match the audio input gain of the DPT 700 bodypack transmitter to the
			microphone connected to the audio input.
TRANSM. POWER			The TRANSM.POWER sub-menu lets you adjust the RF output power of the synchronized trans-
			mitter.
ENCRYPTION			If you turn on the encryption function, the receiver will calculate a unique key every time that you syn-
For details, visit			chronize the transmitter. The receiver uploads the key during the infrared synchronization process.
www.akg.com.			You cannot read out the encryption key and it is not possible to set two transmitters to the same key.

Note: • For transmitters with firmware versions lower than 2.0, select 32-bit encryption. (These trans- mitters will not function with 512-bit encryption.)

•For transmitters with firmware version 2.0 and higher, you can select 512-bit encryption for the highest possible security.

•If you use a backup transmitter you must turn off the signal encryption function.

MUTE LOCK	MUTE LOCK deactivates the mute button on the transmitter. The user of the synchronized transmit-
	ter cannot mute the audio signal locally.
SYNCHR. TRANSMITTER	During the infrared synchronization process the receiver overwrites all previously selected transmit-
	ter settings (Group/Channel, frequency, name, bodypack gain, transmission power, encryption key,
	and mute lock).
	• To program the transmitter to the settings you selected on the receiver, start the transmitter syn-
	chronization from the receiver menu and point the infrared sensor (4) on the transmitter at the
	infrared emitter (8) on the receiver from a distance of 4 inches/10 cm max.

22