Kenwood AUDIO PROCESSOR manual Rear Panel Controls

Page 10

REAR PANEL CONTROLS

21

22

25

19

18 20 22

23

24

(18) MIC SELECT

This three position switch selects the YAESU, KENWOOD or ICOM microphone plugged into the 8 pin Mic Input (19). (Other microphones supported with mic adapters)

(19) MIC INPUT

This Input uses an 8 Pin microphone male connector. The impedance of this input is set by the Audio Input 3 position toggle switch (4). Do not use this connector when RCA Mic In (20) or the Aux Input (21) is being used.

J8		Icom		Ken	Yaesu
J8
Pin
1		+Mic		+Mic
2		+5V		PTT	+5V
5		PTT		+5V	PTT
5		PTT		+5V	Gnd
6		PTT			PTT
6		Gnd			PTT
7		Gnd		- Mic	Gnd
8				Gnd	+Mic
8

-10-

Image 10

Contents Audio Processor W2IHY Table of Contents EQplus Front Panel Controls 3 5 14 15 13Front Panel Controls EQplus BAR Graph MonitoringEqualizer Bass R37 Equalizer On/Off Switch S3Compressor / Downward Expander On/Off Switch S2 Equalizer Treble R38Effects Processor Program Select / OFF Switch S4 Output Level Potentiometer R44 Effects Processor Delay Potentiometer R42Effects Processor Level Potentiometer R47 Monitor Mon Level Potentiometer R39Rear Panel Controls Rear Panel Controls Rear Panel Controls Power Pin Male DINPin Male DIN Getting Started Tutorial Adjusting an External Equalizer connected to the EQplus Using The EQplus headphone Phones MonitorAdjusting the EQPlus Dual Band EQ Adjusting the Effects Getting Started Tutorial Internal Wiring Audio OUT Cable Wiring PIN DIN Audio Output ConnectionPTT GND Audio OUT & Power Cable Wiring HI-ZAudio OUT Cable Wiring