GETTING STARTED TUTORIAL
Audio Input Gain (5) so that 2 or 3 Green Bar Graph LED’s light up. This may require adjusting both the Mic Gain control on the 8 Band EQ and the Audio Gain control on the EQplus.
Using The EQplus headphone (PHONES) Monitor
Connect a set of stereo headsets into the 1/4 inch “Phones” Connector located in the back of the EQplus. Talk into the mic to hear audio coming from the EQplus. Adjust the headset volume by turning the front panel Monitor Level control (17)
Adjusting an External Equalizer connected to the EQplus
If you are using an external audio device, such as a W2IHY
8 Band EQ, use the same equalizer settings you were using prior to using the EQplus.
Adjusting the EQPlus Dual Band EQ
Turn the Equalizer Switch (7) on. Turning the Treble potentiometer (9) clockwise up will increase the amount of high frequencies present in the Audio Out (23) The detent midway through the rotation is 0dB gain point. Turning the Bass potentiometer (8) clockwise will increase the amount of low frequencies present in the Audio Out (23) The detent midway through the rotation is the 0dB gain point. Experimentation will be required to determine the optimal settings for the Equalizer.
USING THE COMPRESSOR/ DOWNWARD EXPANDER
-With the Compressor/ Downward Expander off, the audio level, as seen on the LED Bar Graph, should be adjusted so that 2 or 3 green LED’s are on. This level may be adjusted using the Audio Input Gain control (5).
-Turn the Compressor / Downward Expander on (10). Turn the DE (Downward Expander ) control (12) fully counter clockwise. This will effectively turn the Downward Expander off.
..