REAR PANEL CONTROLS
(23) AUDIO OUTPUTS 1,2 and 3
The audio output and PTT outputs of the EQplus uses these 5 pin DIN’s. When the Audio Output Rotary switch (22) is in the “1” position, audio is active at Audio Output 1. When the Audio Output Rotary switch (22) is in the “2” position, audio is active at Audio Output 2. When the Audio Output Rotary Switch (22) is in the “3” position, audio is active at Audio Output 3. The diagram below shows the configuration of each of the 3 outputs.
AUDIO OUT 1/2/3
5 Pin Male DIN
Din connectors shown on side to be soldered
+ Audio | Balanced |
- Audio | Output |
|
PTT
Gnd
(24) PHONES
This 1/4“ Stereo headphone connector can be used to monitor audio from the EQplus. The output level of this connector is controlled by the Monitor Level control(1). Important: Unless
headphones using 1/4” stereo connectors are used, the EQplus monitor will not operate properly.
(An inline adapter should be used with headsets that do not use 1/4“ stereo connectors. Stores like Radio Shack have such adapters available.)
(25) Power
5 Pin Din connector. 7 - 14 VDC input at 100 ma.
Power
5 Pin Male DIN
Din connectors shown on side to be soldered
GND
+7 to 14V