Kenwood AUDIO PROCESSOR manual Front Panel Controls, 3 5 14 15 13

Page 5

FRONT PANEL CONTROLS

6

8

9

7

11

12

10

16

2

14 3 5 14 15 13 17

This section describes each of the controls on the front panel. You should read through this section now. Some of the descriptions will be more meaningful after you first work through the Getting Started Tutorial.

(1) Power On/Off Switch (S1)

This switch turns the unit's power on and off.

(2) Power on LED (LED1)

This LED goes on when power is on in the unit.

(3) Audio Input Mic PWR (Power) Switch (S6)

Turning this switch on puts +5V onto what is plugged into the Mic In and Aux Input connectors. The Mic power switch must be on if you have any of the following microphones connected directly into the EQplus:

-ICOM HM12, HM36, SM6 etc..

-Heil microphones made specifically for ICOM radio’s such as the HMI and ICM

-Elecract MH2 (made for the Elecraft radio by Heil Sound )

-5-

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Audio Processor W2IHY Table of Contents EQplus 3 5 14 15 13 Front Panel ControlsEQplus BAR Graph Monitoring Front Panel ControlsCompressor / Downward Expander On/Off Switch S2 Equalizer On/Off Switch S3Equalizer Bass R37 Equalizer Treble R38Effects Processor Program Select / OFF Switch S4 Effects Processor Level Potentiometer R47 Effects Processor Delay Potentiometer R42Output Level Potentiometer R44 Monitor Mon Level Potentiometer R39Rear Panel Controls Rear Panel Controls Pin Male DIN Power Pin Male DINRear Panel Controls Getting Started Tutorial Adjusting the EQPlus Dual Band EQ Using The EQplus headphone Phones MonitorAdjusting an External Equalizer connected to the EQplus Adjusting the Effects Getting Started Tutorial Internal Wiring PIN DIN Audio Output Connection Audio OUT Cable WiringPTT GND HI-Z Audio OUT & Power Cable WiringAudio OUT Cable Wiring
Top Page Image Contents