Avaya LUMULZMIC manual Operation, Typical Connections to a Lupcm Paging System Controller Unit

Page 7

Figure 5 shows the wiring diagram for connecting microphones to an Avaya

LUPCM Paging System Controller Unit.

I

Figure 5. Typical Connections to a LUPCM Paging System Controller Unit

Operation

To make a short page, press and hold the larger, momentary contact push-button. To make a longer page, press the smaller locking push-button; when the page is over, press this button again to deactivate. Use the DTMF pad to select zone addresses or implement paging features; refer to your Amplifier Manual for zone options.

The three LEDs on the front panel show paging status. A flashing yellow LED indicates a long term page. The red LED indicates a busy condition on the system. The green LED indicates that the microphone is on and ready to initiate a page (even when the unit is paging).

The volume can be adjusted for an individual microphone by using the screwdriver- accessible output level at the back panel (see Figure 2).

Page 7 of 7

Page 6 Page 7
Image 7
Page 6 Page 7
Contents Multi-Zone Microphone Important Safety Information Contents Multi-Zone Microphone Features OUT PUT S Y Contact S S Closure InstallationTypical Connections to a Telephone Paging Amplifier Typical Connections to a Lupcm Paging System Controller Unit Operation
Top Page Image Contents