Revolabs 02-HDDUAL, 04-HDDUALEU, 02-HDSGL Using the HD Wireless Adapter for Countryman Microphone

Page 15

Note: The Adapter does not provide phantom power or bias current so it cannot be used with condenser or electret microphones.

2.With the microphone attached, un-mute the Adapter by pressing and releasing the Mute button (confirm by a flashing GREEN LED).

Note: If the microphone has an on-board mute switch, this switch must also be un-muted prior to use.

3.To turn the Adapter off, return the microphone unit to the Charger Base or press and hold the Mute button for ~10 seconds until the LED turns solid RED then release button.

Important: Always remove the microphone from the Adapter by pressing the latch switch and separating the parts before returning the Adapter to the Charger Base.

If the Adapter is moved too far from the Base Station (~65 feet or 20 meters) the connection will be dropped (LED flashes all colors) and the audio will mute. After 15 seconds the microphone will beep 5 times, and will continue beeping every 30 seconds to indicate that it is out of range.

Move the XLR Adapter closer to the Base Station and the connection will automatically be re- established to its original state, and the beeping will cease. If not, the XLR Adapter will continue beeping until it turns off in about 15 minutes.

Using the HD Wireless Adapter for Countryman Microphone

The HD Wireless Adapter for Countryman Microphones, shown in the following figure, is connects to a Countryman microphones for wireless freedom for broadcasting applications with no bulky equipment, such as a belt pack or batteries.

5

1

4

 

2

3

- 12 -

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Models 02-HDSGL, 02-HDDUAL, 04-HDSGLEU and 04-HDDUALEU Revolabs HD Single/Dual Wireless Microphone SystemD S G L M a N P a P 1 1 M a r c h 2 0 1 0 R e v 1 Contents Safety and General Information Standards to which Conformity is declared Export Law AssurancesEuropean Compliance Model NumbersSystem Components IntroductionInstalling the Revolabs HD Base Station Controls and Connections5 4 How large is the room? Configuring the Revolabs Hdtm Base StationIs Line Level or Mic Level signal required? Revolabs HD Base Station Audio ConnectionsDIP Switch 3 Audio Output Level Using the Rear Panel Configuration DIP SwitchesConfiguration Settings DIP Switch 1- Output Mixing DIP Switch 2 Low Pass FilterRevolabs HD Microphones and HD Microphone Adapters Using the HD Wearable Wireless MicrophonesDIP Switch 5&6 Microphone EQ DIP Switch 7&8 Transmit PowerAdjusting the Volume on the Wearable Microphone Earpiece 360 º Pickup Pattern Acoustic Cover protects microphone element non-removable Using the HD XLR Microphone Wireless Adapter Using the HD Wireless Adapter for Countryman Microphone Pairing Wireless Microphones to Base Station Power Module Revolabs Hdtm Single or Dual Charger BaseCharging the Microphone Batteries Dispose of batteries in a fire because they may explode Updating the Revolabs Hdtm FirmwareYELLOW, Green Revolabs HD Indicator LEDsWarranty Dimensions, L, W, H and Weight SpecificationsCharger Bays Power Cord ReceptacleLED indicator IndexV o l a b s H D S i n g l e & D u a l M a n u a l
Top Page Image Contents