Specifications†, Overall System | Audio-Technica G, H92-TH, L

Specifications†

Operating Frequency	VHF high band, 169 MHz to 172 MHz
Frequency Stability	±0.005%

Modulation Mode	FM
Maximum Deviation	±15 kHz

Operating Range	200' typical

Operating Temperature Range	40° F (4° C) to 110°F (43° C)

Frequency Response	80 Hz to 13 kHz
RECEIVER

Receiving System	Non-diversity, single-channel,
	dual antenna system

Image Rejection	50 dB minimum
Signal-to-noise Ratio	80 dB at 10 kHz deviation (IEC-weighted),
	maximum modulation 15 kHz

Total Harmonic Distortion	≤1% (10 kHz deviation at 1 kHz)
Sensitivity	20 dBµV for 60 dB S/N (IEC-weighted)
Audio Output	350 mV (1 kHz modulation, 10 kHz
	deviation, 100k ohm load)

Output Connector	1/4" TS (“mono”) phone jack

Power Supply	100-240V AC (50/60 Hz) to 12V DC 1A
	(center positive) switched mode external
	power supply
Dimensions	7.48" (190.0 mm) W x 1.65" (42.0 mm) H x
	5.12" (130.0 mm) D

Net Weight	11.0 oz (311 grams)

Accessories Included	Power supply

RF Power Output	High: 10 mW; Low: 2 mW, typical
Spurious Emissions	Under Federal Regulations

Dynamic Range	≥90 dB, A-weighted
Input Connections	High impedance, low impedance, bias
Battery (not included)	9V (NEDA type 1604) alkaline

Current Consumption	30 mA typical

Battery Life	Approximately 15 hours (High);
	20 hours (Low), depending on battery type
	and use pattern

Dimensions	2.56" (65.0 mm) W x 4.33" (110.0 mm) H
	x 1.00" (25.4 mm) D

Net Weight (without battery)	2.8 oz (78 grams)
HANDHELD TRANSMITTER

RF Power Output	High: 10 mW; Low: 2 mW, typical

Spurious Emissions	Under Federal Regulations
Dynamic Range	≥90 dB, A-weighted

Microphone Element	Dynamic unidirectional

Battery (not included)	9V (NEDA type 1604) alkaline

Current Consumption	30 mA typical
Battery Life	Approximately 15 hours (High);
	20 hours (Low), depending on battery type
	and use pattern

Dimensions	9.50" (241.3 mm) long, 2.10" (53.3 mm)
	maximum diameter

Net Weight (without battery)	12.7 oz (360 grams)

Accessory Included	AT8456a Quiet-Flex™stand clamp

†In the interest of standards development, A.T.U.S. offers full details on its test methods to other industry professionals on request.